订购热线：ASI133-S00/SA3S0 ASI533-S00/SS3S0
ASI133-H00/SA3S0 ASI533-H00/SS3S0
ASI133-S00/SA3D0 ASI533-S00/SS3D0
ASI133-H00/SA3D0 ASI533-H00/SS3D0
AST143-S00 ASR133-S00 ASD143-P00 ASD533-S00
AST143-S00/ST4S0 ASR133-S00/SR3S0 ASD143-P00/SB4S0 ASD533-S00/SD3S0
AST143-S00/ST4D0 ASR133-S00/SR3D0 ASD143-P00/SB4D0 ASD533-S00/SD3D0
<Toc> <
● Input Signal Values (RV1, RV2, RV3)输入信号值
The input signal values (RV1, RV2, RV3) are input data handled by the Signal selector blocks.输入信号值(RV1, RV2, RV3)是被信号选择器块用来处理的输入数据
Use the Function Block Detail Builder to set the engineering unit and scale range of input signal values. The input signal values (RV1, RV2, RV3) are regarded as having the same engineering unit and scale range as those of the selected signal value (PV).通过功能块的Detail Builder设置输入信号值的工程单位和量程。这些输入信号值(RV1, RV2, RV3)被认作和PV值具有相同的工程单位和量程ASI133-S00/SA3D0。
● Reset Limit Values (RLV1, RLV2)复位限制值
The reset limit values (RLV1, RLV2) are input data that are handled by a controller block when the reset limit function is used.
The reset limit values (RLV1, RLV2) are regarded as having the same engineering unit and scale range as those of the manipulated output value (MV). 当复位限制功能使用时，复位限制值(RLV1, RLV2)会作为一个控制块的输入数据被处理。这些复位限制值(RLV1, RLV2)被认作和MV具有相同的工程单位和量程ASI133-S00/SA3D0。
● Input or Output Compensated Value (VN)输入或输出补偿值
The engineering unit and scale range are not defined for input compensated values (VN) received from the BIN terminal, as the numeric data of input compensated values (VN) taken in from outside are used directly for input or output compensation computation.从补偿输入端BIN接收的输入补偿值(VN)没有指定工程单位和量程，因为从外部获得的输入补偿的数值是直接用于输入或输出补偿计算ASI133-S00/SA3D0。
● Tracking Switch (TSW)跟踪开关
The data handled by the tracking switch (TSW) for the TSI terminal must be an integer value of “
跟踪开关输入端（TSI）的被跟踪开关(TSW)处理的数据必须是0或1。1和0分别指示ON 和OFF。
